98 DIVIDING EQUIPMENT SPECIFICATIONS Unit: mm Model Suitable for A B C CenterHeight E F Weight (kg) Max. Min. TS-4 CC-6"/CS-6" 125 147 16 138 115 194 177 8.2 TS-5 CC-8"/CS-8" 123 194 16 170 130 204 184 8.6 SPECIFICATIONS Model DIRECT INDEXING A B C D E a b h g Diameterof hole(turret) Weight (kg) CC-6" 2,3,4,6 8,12,24 260 218 133 167 27 190 110 125 16 44 23 CC-8" 312 270 157 210 28 220 135 150 16 63 41 SIMPLEINDEXINGSPACER Model: CC-6”, CC-8” The Simple Indexing Spacer can bemounted onmilling machines, drillingmachines and other machine tool where an indexing facility is required. The 3-jaw chucks of both the CC-6” and the CC-8” models have a large through bores of 44mmand 63mm respectively. These Indexing Spacers are designed for using in horizontal or vertical positions. Themaster Indexing plate has 24 divisions and is permanently xed inside the indexer. Divisions of 2, 3, 4, 6, 8 and 12 can also be achieved by the use of the sub-plates, which can be installed quickly following these steps: 1. Open Rear Cover 2. Insert Plate 3. Close Cover 4. Loosen Locking Handle 5. Move Dividing Pin so as to separate it from theMaster Plate. 6. Turn the Chuck. When theMaster Plate and Sub Plate are aligned the Pinwill lock into the slot automatically. 7. Fasten Locking Handle ready for machining. REMARK: "Operation and Service Manual" is included for reference OPTIONAL ACCESSORIES: • Tail Stock TS-4 for CC-6” TS-5 for CC-8” • 3-JawChuck 6” 3-JawChuck for CC-6” 8” 3-JawChuck for CC-8” TAILSTOCKFORCC,CS-TYPE Model: TS-4, 5 When using indexing spacers in vertical position, these Tail Stocks can be used to support theworkpiece and ensure accurate alignment.
RkJQdWJsaXNoZXIy ODM5NzM=